From 5cf1c38ea1eec0045a551282fa356cbcbec97c5c Mon Sep 17 00:00:00 2001 From: esenapaj Date: Wed, 23 Dec 2015 08:12:54 +0900 Subject: [PATCH] Update Configuration_adv.h --- .../delta/kossel_mini/Configuration_adv.h | 28 +++++++------------ 1 file changed, 10 insertions(+), 18 deletions(-) diff --git a/Marlin/example_configurations/delta/kossel_mini/Configuration_adv.h b/Marlin/example_configurations/delta/kossel_mini/Configuration_adv.h index 172519395..e3d85ad88 100644 --- a/Marlin/example_configurations/delta/kossel_mini/Configuration_adv.h +++ b/Marlin/example_configurations/delta/kossel_mini/Configuration_adv.h @@ -36,16 +36,6 @@ #define THERMAL_PROTECTION_BED_HYSTERESIS 2 // Degrees Celsius #endif -/** - * Automatic Temperature: - * The hotend target temperature is calculated by all the buffered lines of gcode. - * The maximum buffered steps/sec of the extruder motor is called "se". - * Start autotemp mode with M109 S B F - * The target temperature is set to mintemp+factor*se[steps/sec] and is limited by - * mintemp and maxtemp. Turn this off by excuting M109 without F* - * Also, if the temperature is set to a value below mintemp, it will not be changed by autotemp. - * On an Ultimaker, some initial testing worked with M109 S215 B260 F1 in the start.gcode - */ #if ENABLED(PIDTEMP) // this adds an experimental additional term to the heating power, proportional to the extrusion speed. // if Kc is chosen well, the additional required power due to increased melting should be compensated. @@ -56,14 +46,16 @@ #endif #endif - -//automatic temperature: The hot end target temperature is calculated by all the buffered lines of gcode. -//The maximum buffered steps/sec of the extruder motor are called "se". -//You enter the autotemp mode by a M109 S B F -// the target temperature is set to mintemp+factor*se[steps/sec] and limited by mintemp and maxtemp -// you exit the value by any M109 without F* -// Also, if the temperature is set to a value B F + * The target temperature is set to mintemp+factor*se[steps/sec] and is limited by + * mintemp and maxtemp. Turn this off by excuting M109 without F* + * Also, if the temperature is set to a value below mintemp, it will not be changed by autotemp. + * On an Ultimaker, some initial testing worked with M109 S215 B260 F1 in the start.gcode + */ #define AUTOTEMP #if ENABLED(AUTOTEMP) #define AUTOTEMP_OLDWEIGHT 0.98