Don't include Z_RAISE_AFTER_PROBING if not used (PR#2527)
This commit is contained in:
parent
81bba7ed88
commit
bea6739774
@ -1425,8 +1425,11 @@ static void setup_for_endstop_move() {
|
||||
|
||||
// Move up for safety
|
||||
feedrate = Z_PROBE_ALLEN_KEY_STOW_1_FEEDRATE;
|
||||
destination[Z_AXIS] = current_position[Z_AXIS] + Z_RAISE_AFTER_PROBING;
|
||||
prepare_move_raw(); // this will also set_current_to_destination
|
||||
|
||||
#if Z_RAISE_AFTER_PROBING > 0
|
||||
destination[Z_AXIS] = current_position[Z_AXIS] + Z_RAISE_AFTER_PROBING;
|
||||
prepare_move_raw(); // this will also set_current_to_destination
|
||||
#endif
|
||||
|
||||
// Move to the start position to initiate retraction
|
||||
destination[X_AXIS] = Z_PROBE_ALLEN_KEY_STOW_1_X;
|
||||
@ -1610,7 +1613,9 @@ static void setup_for_endstop_move() {
|
||||
|
||||
float oldXpos = current_position[X_AXIS]; // save x position
|
||||
if (dock) {
|
||||
do_blocking_move_to_z(current_position[Z_AXIS] + Z_RAISE_AFTER_PROBING); // raise Z
|
||||
#if Z_RAISE_AFTER_PROBING > 0
|
||||
do_blocking_move_to_z(current_position[Z_AXIS] + Z_RAISE_AFTER_PROBING); // raise Z
|
||||
#endif
|
||||
do_blocking_move_to_x(X_MAX_POS + SLED_DOCKING_OFFSET + offset - 1); // Dock sled a bit closer to ensure proper capturing
|
||||
digitalWrite(SLED_PIN, LOW); // turn off magnet
|
||||
} else {
|
||||
@ -2766,7 +2771,11 @@ inline void gcode_G28() {
|
||||
// adjust for inaccurate endstops, not for reasonably accurate probes. If it were
|
||||
// added here, it could be seen as a compensating factor for the Z probe.
|
||||
//
|
||||
current_position[Z_AXIS] = -zprobe_zoffset + Z_RAISE_AFTER_PROBING + (z_tmp - real_z);
|
||||
current_position[Z_AXIS] = -zprobe_zoffset + (z_tmp - real_z)
|
||||
#if ENABLED(SERVO_ENDSTOPS) || ENABLED(Z_PROBE_ALLEN_KEY) || ENABLED(Z_PROBE_SLED)
|
||||
+ Z_RAISE_AFTER_PROBING
|
||||
#endif
|
||||
;
|
||||
// current_position[Z_AXIS] += home_offset[Z_AXIS]; // The probe determines Z=0, not "Z home"
|
||||
sync_plan_position();
|
||||
}
|
||||
|
Loading…
Reference in New Issue
Block a user