BLTouch.init should not deploy (#13988)

Low or unknown probe clearance on init (even at powerup) is a risk and therefore, a deploy should be avoided because dragging the pin is possible: A deploy goes into alarm if it can't extend fully and then the subsequent stow will fail.
This commit is contained in:
FanDjango 2019-05-15 06:55:11 +02:00 committed by Scott Lahteine
parent 211563e533
commit dcaefc68a5

View File

@ -49,7 +49,8 @@ void BLTouch::init() {
#if ENABLED(BLTOUCH_FORCE_5V_MODE)
_set_5V_mode(); // Set 5V mode if explicitely demanded (V3 upwards)
#endif
clear();
_reset();
_stow();
// There really should be no alarm outstanding now, and no triggered condition. But if there is,
// there is no need to worry people here on init right at the start of the printer.
}