diff --git a/Marlin/Configuration_adv.h b/Marlin/Configuration_adv.h
index 0431b002f..2846f9a67 100644
--- a/Marlin/Configuration_adv.h
+++ b/Marlin/Configuration_adv.h
@@ -151,12 +151,9 @@
 #endif
 
 #if TEMP_SENSOR_CHAMBER
-  // Make sure you define where your heater is connected, the following works on a BTT SKR 1.4 Turbo
-  // using the secondary tool heater output. (FAN1 by default).
-  //#define FAN1_PIN                   -1   // Remove the fan signal on pin P2_04 (SKR 1.4 Turbo specific)
-  //#define HEATER_CHAMBER_PIN      P2_04   // Chamber heater on/off pin (HE1 connector on SKR 1.4 Turbo)
-
+  //#define HEATER_CHAMBER_PIN      P2_04   // Required heater on/off pin (example: SKR 1.4 Turbo HE1 plug)
   //#define HEATER_CHAMBER_INVERTING false
+  //#define FAN1_PIN                   -1   // Remove the fan signal on pin P2_04 (example: SKR 1.4 Turbo HE1 plug)
 
   //#define CHAMBER_FAN               // Enable a fan on the chamber
   #if ENABLED(CHAMBER_FAN)