Added description in the documentation for the new parts.

This commit is contained in:
Edward Patel 2015-04-01 21:32:28 +02:00
parent 6b91b7b411
commit 6bdebede27

View File

@ -28,6 +28,10 @@ In `Configuration.h` there are two options that can be enabled.
There are also some values that can be set.
The following will set the step distance used when manually turning the display encoder. Default is 0.025
`MBL_Z_STEP`
Following four define the area to cover. Default 10mm from max bed size
`MESH_MIN_X`<br/>
@ -55,14 +59,14 @@ When selecting this option the printer will first do a homing, and then travel t
If the EEPROM has been enable it can be good to issue a `M500` to get these points saved.
Issuing a `G29` will return the state of the mesh leveling.
Issuing a `G29` will return the state of the mesh leveling and report the probed points.
Probing the bed with G-codes
----------------------------
Probing the bed by G-codes follows the sequence much like doing it with the display.
`G29` or `G29 S0` will return the state bed leveling.
`G29` or `G29 S0` will return the state of the bed leveling and report the probed points. Where X=1 Y=1 is the top-left value and X=MESH_NUM_X_POINTS Y=MESH_NUM_Y_POINTS is bottom-right value. X per column and Y per row.
`G29 S1` will initiate the bed leveling, homing and traveling to the first point to probe.
@ -70,6 +74,8 @@ Then use your preferred Printer controller program, i.e. Printrun, to lower the
`G29 S2` will store the point and travel to the next point until last point has been probed.
`G29 S3 Xn Yn Zn.nn` will modify a single probed point. This can be used to tweak a badly probed point. Specify probe point where `Xn` and `Yn`, where `n` in `Xn` is between 1 and `MESH_NUM_X_POINTS`. Likewise for `Yn`. `Zn.nn` is the new Z value in that probed point.
Note
----